Rough Country 909 - Manual (Page 14)

24. Install the differential bracket as shown using the 14mm x 50mm bolts and flat washers. See Photo 19. Tighten us-
ing a 7/8” wrench.
25. Adjust the arm to a measurement of 34 1/2” from center of eye to center of eye and tighten jam nut.
26. Install the lower arm in the frame bracket using the supplied 9/16” x 4 1/2” bolts, flat washers and lock nuts. See
Photo 20. Do not tighten at this time.
27. Install the lower arm on the axle using the stock hardware. See Photo 21. Do not tighten at this time.
28. Assemble the rear upper y-link with the flex joint to a measurement of 7 3/8’ from the flat edge of the center brace to
the center of the flex joint. Install the new y-link in the factory location on the frame using the factory hardware and
tighten using a 15mm socket. See Photo 22.
29. Install the Y-link to the new axle bracket with the supplied 9/16” x 4 1/2” Bolt, flat washers and lock nut. See Photo
23. Tighten using a 21mm x 22mm socket / wrench.
30. Reinstall the brake line brackets to the tabs on the Y-link arm with the supplied 1/4” x 3/4” bolts, flat washers and
lock nuts. See Photo 24.
Photo 19
Install the differential bracket Install the rear lower arm in the frame bracket
Photo 20
Photo 21 Photo 22
Photo 23
Install the rear lower arm on the axle Install the upper arm on the frame
Install the upper arm on the axle bracket Reinstall the stock brake line brackets on tabs
Photo 24