Rough Country 1182 - Manual

92118200
INSTRUCTION SHEET
Rough Country recommends certified technicians install our products. Please read instructions before beginning installation.
Check the kit hardware against the parts layout and list found on this instruction sheet. Be sure you have all needed parts and
know where they go.
“SKIDBRACE” INSTALLATION INSTRUCTIONS
1. Remove lower hex head bolt from frame to steering box.
Remove driver side bolt on bottom of front bumper (on
aftermarket bumpers drilling and tapping a hole may be
required). Retain these two bolts for reuse.
2. Place “skidbrace” into location. Using supplied locktite
install bolt into steering box. Re-install bolt on front
bumper.
3. Using locktite install longer set screw on driver’s side of
skid plate. Again using locktite, install shorter setscrew
on passenger side of skid brace. Tighten setscrews until
“skidbrace” is held firmly in position, do not over
tighten.
Page 1
Kit Contents
• “Skidbrace”
• Setscrew long (1)
• Setsrew short (1)
• Locktite (1)
MAINTENANCE INFORMATION
It is the ultimate buyers responsibility to have all bolts/nuts checked for tightness after the first 100 miles and then every 1000
miles.