Toner Cable TVM9150PKG Multiformat 3G-HD-SD Video Waveform Monitor and Audio Signal Analyzer User Manual
Page 11
969 Horsham Road
l
Horsham, Pennsylvania 19044 USA
l
Phone: 215-675-2053 Fax: 215-675-7543
l
Signal To Noise: Outputs (Digital)
100 dB (relative to signal level out of +24 dBu), typical 4 AES/EBU and one Dolby®
Digital, Dolby® E, or AES stream embedded in the selected digital video source
Output Connector
4 BNC, female shared with input
Impedance
75 ohms
Control
GPI
9 total with 4 input and 5 preset recall selections, or individually user configured
GPO
2 alarms, user-configured
Connector
26-pin HD (high-density) D-sub, female
Input Impedance
10 k ohms returned to 5 VDC
Alarm Output
Relay closure
Maximum Relay Current
350 mA @30 VDC
External Router Control
1 RJ11 female, for use with Videotek RS-12A router for input expansion
Peripheral Interface
USB 1.1 supporting storage devices, and keyboard
Connector
USB 1.1, Type A, female
Communications
Ethernet port - 10/100Base-T
Connector
RJ45 Ethernet female
Timecode
Input
LTC, Ancillary Time Code (HD only), DVITC extracted from SD inputs
Display
General
A quadrant display for viewing an input on up to four different displays as picture,
waveform, vector, audio, alarm status, timing, optional eye pattern, simultaneously
or individually as a full-screen display of each separately. Additional data analyzer
display for pixel analysis. Also view multiple waveform and vectors of the same or
different inputs
Waveform
Composite, YC
B
C
R
or RGB, parade/overlay of like formats
Sweep Time Base
1 or 2 H, with x1, x5 and x10 horizontal magnification 1 or 2 V with x1, x5 and x25
horizontal magnification
Waveform Accuracy
≤1%
Waveform Frequency Response
Analog: 25 Hz to 5.75 MHz within ±1% of amplitude at 50 kHz
HD:
±0.5% to 30 MHz Y
±0.5% to 15 MHz C
B
, C
R
SD:
±0.5% to 5.75 MHz Y
±0.5% to 2.50 MHz C
B
, C
R
7903.*0XOWLIRUPDW*+'6'9LGHR:DYHIRUP0RQLWRUDQG$XGLR6LJQDO$QDO\]HU