Veris Industries Badger 3000 SERIES Install - Manual (Page 7)

7
For example: pressing the Menu from the normal screen
shows the “ RESET SETUP DIAG” screen Pressing the
▲key brings up the Reset Screens; the ▼key brings up
the Setup Screens, and the ►key brings up the Diag-
nostic Screens. If the ▼key is pressed the screen would
appear as follows
Option List Screens
Units of measure is an example of an options list.
Pressing the ▲key scrolls up the list while the ▼key
scrolls down through the list.
In this case starting with GPM; gal/s; gal/hr;…LPM;….
ending in a selection of Custom units.
Pressing the Enter key completes the selection. Pressing
the Menu leaves the selection unchanged.
The ►key has no function on this type screen.
Data Screens
Some screens are Data Entry screens (Examples: Set-
Points or Custom units).
When this screen is first displayed, the current value will
be displayed. The cursor will be flashing the most left
hand digit. Pressing the ▲ key will increase the value,
the ▼ key will reduce it.
If the cursor is flashing the decimal point pressing the ▲
key will move the decimal point to the right, pressing the
▼ key will move the decimal to the left.