Spicer TPCS (Tire Pressure Control System) Service Manual - Manual (Page 55)

55
Tire Pressure Control System Programming
Spicer’s Tire Pressure Control System features on
location programming through the Operator Control
Panel. Programmable settings include:
• Individual pressure settings for the steer, drive
and trailer axles.
• Loaded and unloaded axle programming for
highway, off highway and emergency condi-
tions.
• Overspeed warning for highway, off highway
or emergency conditions.
Enter the Tire Pressure Control System programming
sequence by pressing the SELECT and L/U buttons at
the same time. A flashing bar or psi verifies that you
are in the programming mode and also indicates that
the first selection, English or metric values, is ready for
programming. Refer to Figure 40 for sample proce-
dure.
Press up/down arrows to select options or change
settings (pressure or speed) and press SELECT button
to record a selection in memory and move to the next
step.
Press the SELECT button repeatedly to move through
the program steps, one step for each time the SELECT
button is pressed. Refer to the programming reference
chart for specific Tire Pressure Control System pres-
sure and speed programming steps.
To complete the programming sequence, or exit the
programming mode, continue to press SELECT button
to step through to the end of the procedure.
Note: If no buttons are pressed for more than one
minute, the Operator Control Panel will end the pro-
gramming sequence, saving any changes made during
programming.
Tire
P
ress
ure
Co
ntr
ol
Sys
te
m Pr
ogr
ammi
ng
Operator Controls
Tire
P
ress
ur
e
Co
ntro
l
Syste
m
P
ro
gr
am
m
in
g