Soft dB Opus Suite SLM & 3Vib Module - Manual (Page 9)

6
4 Quick Start
The AutoStore Setup is presumed to set to OFF.
Step 1 Set the Averaging Time
Click on the field to change the Leq Averaging Time. A numerical key pad will appear to
allow this change.
Step 2 Start the Measurement
Click on the button to start a measurement. The measurement will be performed
according to the current measurement setup.
The measurement can be paused by clicking the button and can be resumed by clicking
the button.
Step 3 Stop the Measurement
The measurement will stop at the end of the Leq Averaging Time. However, the user can stop the
measurement at any time by clicking the button.
Step 4 Save the Measurement
Click on the button to save the measurement. The measurement will be saved in a
DataSet in the Record Directory (see section 8.1, p. 42) and its ID is specified in the Current ID
Indicator (see section 5.2, p. 10).
Once the measurement is saved in a dataset, the button is disabled.
The next table shows the left pane appearance before, during and after a measurement.