Ohaus AP250E ANALYTICAL Plus Electronic Balances - Manual (Page 63)

63
Initialize (Cont.) Initialize (Cont.) Initialize (Cont.) Initialize (Cont.) Initialize (Cont.)
11. After the last digit is entered, is displayed again.
12. for the high limit.
13. indicates current high end value.
14. Repeat steps 8 through 10 to change the numbers as required.
15. After the last digit is entered, displayed again.
16. .
17. .
Print Stable Data Only Print Stable Data Only Print Stable Data Only Print Stable Data Only Print Stable Data Only
When enabled, this feature permits only stable display data to be output. To set the
feature ON or OFF, proceed as follows:
1. Access the submenu under the Print Options menu.
2. .
3. or .
4. .
Print Numeric Data Only Print Numeric Data Only Print Numeric Data Only Print Numeric Data Only Print Numeric Data Only
This submenu is used to select numeric data only, or full display data for RS232 output.
Set this feature ON to output numeric display data only, or OFF to output full display
data as follows:
1. Access the submenu under the Print Options menu.
2. .
3. or .
4. .
MENUS