Ohaus AP250E ANALYTICAL Plus Electronic Balances - Manual (Page 57)

57
PRINT OPTIONS
Auto Print
Cont, interval,
on stb,off
off off off off
Initialize Auto Print
Interval, non print lo,
non print hi
Stable Data
ON/OFF OFF OFF OFF OFF
Numeric Data
ON/OFF OFF OFF OFF OFF
Time
ON/OFF OFF OFF OFF OFF
Date
ON/OFF OFF OFF OFF OFF
Reference
ON/OFF OFF OFF OFF OFF
End, Print Options
LIST
END, PRINT
PRINT MENU PRINT MENU PRINT MENU PRINT MENU PRINT MENU
RESET
YES/NO
COMMUNICATION
Baud
300, 1200, 2400
2400 2400 2400 2400,
4800, 9600
Data Bits
7
7 7 7 7 or 8
Parity Bit
Odd, Even, None
None None None None,
1, 0
Stop Bits
1 or 2
2 2 2 2
End, Comm.
GLP
ID #
Project #
End,GLP
PRINT MENU PRINT MENU PRINT MENU PRINT MENU PRINT MENU
The Print menu provides a number of options which includes: reset, communications,
good laboratory practices, print options, and list.
Reset sets all submenus contained
in the Print menu to factory default settings. Communication specifies baud rate,
number of data bits, parity bit type and stop bits. GLP Good laboratory practices
permits the entering of your own identification number and project number which
shows up on printing.
Print Options Enables/disables Auto print feature, specifies time
interval for automatic output of displayed data and/or exclude a range of weights from
being output. The following items can be turned on or off: Stable data-only feature,
numeric only or full display data for output, time and date. Items shown in bold type
are default settings. Items shown in italics in the print menu below appear only if the
appropriate Functions are turned on.
Print Menu Protection Print Menu Protection Print Menu Protection Print Menu Protection Print Menu Protection
The Print menu may be locked out to prevent unauthorized personnel from changing
settings. If SAFE is displayed, the Print menu has been locked out. Settings may be
viewed but not changed. To lock out the Print menu or unlock, refer to the section titled
Menu Lock-Out Protection.
MENUS