Ohaus AP250E ANALYTICAL Plus Electronic Balances - Manual (Page 12)

12
hhmmss hhmmss hhmmss hhmmss hhmmss TIME TIME TIME TIME TIME Set current time to "hh: mm: ss", hh is between 0 - 23.
TIME TIME TIME TIME TIME Print current time.
mmddyy DATE mmddyy DATE mmddyy DATE mmddyy DATE mmddyy DATE Set current date 'mmddyy'.
DATE DATE DATE DATE DATE Print current date.
% % % % % Print current % ref.
# # # # # Print current ref., any function.
AC AC AC AC AC Abort calibration /Test.
C C C C C Start an auto calibration.
E E E E E Go to initial state of current function.
F F F F F Print current function.
M M M M M Same as mode button.
xD xD xD xD xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON).
ID ID ID ID ID Print current ID string.
xxxxID xxxxID xxxxID xxxxID xxxxID Enter ID string (xxxx limit to 8 characters).
RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE
Field: Mode Stab CR LF
Length: 5 1 1 1
blank if stable
“ ? ” if unstable
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
? ? ? ? ? Print current unit.
0 = minimum level
1 =
2 = maximum level
xI xI xI xI xI Set averaging level to "x", where x = 0, 1,
2
G
RAMS
, D
WT
, C
ARAT
, O
Z
A
V
, O
Z T
, G
RAIN
,
T
AEL
1, T
AEL
2, T
AEL
3, M
OMME
, C
USTOM
U
NIT
xM xM xM xM xM Places balance in mode "x",
where x = 1 to 11 (see table).
If unit is not already enabled,
command will be ignored.
1 = grams
2 = pennyweight
3 = carats
4 = avoidupois ounces
5 = troy ounces
6 = grains
7 = taels
8 = mommes
11 = custom unit
P P P P P Print display data
When “numeric only” display
data is selected for output in
the RS232 menu, the Mode
field is not output.
Field: Weight Mode Stab CR LF
Length: 10 1 5 1 1 1
Same as ?
command
Displayed weight sent right justified
w/lead zero blanking.
Nine characters include:
decimal point (1)
weight (7 max))
polarity (1): blank if positive
“ - ” if negative
INSTALLATION