Ohaus AP250E ANALYTICAL Plus Electronic Balances - Manual (Page 60)

60
Parity Parity Parity Parity Parity
Parity can be set to Odd, Even or None. The default setting is None. To set parity,
proceed as follows:
1. Access the submenu.
2. .
3. , ,
.
4. .
Stop Bits Stop Bits Stop Bits Stop Bits Stop Bits
The number of stop bits can be set to 1 or 2. The default setting is 2. To set stop bits,
proceed as follows:
1. Access the submenu.
2. .
3. or .
4. .
Good Laboratory Practice (GLP) Good Laboratory Practice (GLP) Good Laboratory Practice (GLP) Good Laboratory Practice (GLP) Good Laboratory Practice (GLP)
This submenu enables the storage of an identification number and/or a project
number. When entered into the balance, the identification number and project number
are available when printing. The reason the entries are made under the Print
submenu, is that when legal for trade operation (LFT) is enabled, the Setup submenu
is locked out, leaving the Print submenu free to make entries.
1. Access the submenu.
2. .
3. first digit is flashing.
4. changes the value of the first digit.
MENUS