Ohaus AP250E ANALYTICAL Plus Electronic Balances - Manual (Page 56)

56
Lockswitch Lockswitch Lockswitch Lockswitch Lockswitch
Lockswitch enables you to lock out one or more menu selections. Each menu can be
individually locked on or off
after all functions have been set after all functions have been set after all functions have been set after all functions have been set after all functions have been set . The Calibration Calibration Calibration Calibration Calibration, User, User, User, User, User,
Setup Setup Setup Setup Setup and Print Print Print Print Print menus can be individually locked on or off by selecting the
appropriate menu and then locked by the switch located under the front of the control
panel. See Menu Lockout Section. Cal Test under Calibration remains functional with
the Lockswitch On or Off. Before performing the lockout procedure, decide which
functions of the balance are to be locked on or off.
1. Access the submenu which is under the Setup menu.
2. to access either Calibration, User, Setup or Print menus.
3. to access selected desired menu.
4. to select or .
YES = locked, NO = not locked. YES = locked, NO = not locked. YES = locked, NO = not locked. YES = locked, NO = not locked. YES = locked, NO = not locked.
5. to accept.
6. to change to other menus.
7. To change other menus, repeat steps 2 through 5.
List List List List List
This submenu can be used to output a listing of current menu settings via the RS232
interface. When selected, all menu settings for the User, Setup and Print menus will
be output either to an external printer or computer. To use this feature, your balance
must be connected to a computer or printer.
1. Access the submenu under the Setup or Print menus.
2. . The display
indicates a series of dots traveling right to left when the balance is sending
information.
Exit Setup Menu Exit Setup Menu Exit Setup Menu Exit Setup Menu Exit Setup Menu
1. .
NOTE NOTE NOTE NOTE NOTE: If any Setup parameter is different from previous settings, indicator SETUP in
the display flashes while the balance is storing new settings. Proceed with next step.
2. .
MENUS