Ohaus AP250E ANALYTICAL Plus Electronic Balances - Manual (Page 43)

43
Type Approved/LFT Type Approved/LFT Type Approved/LFT Type Approved/LFT Type Approved/LFT
LFT can be set to ON or OFF. Selecting ON automatically sets the parameters shown
in the table to conform to type approved requirements. For sealing method, refer to
Type Approved Sealing section. Default setting are shown as follows:
Lockswitch Menu Setup Locked
Print Stable Data Only ON
Weighing Units Weighing Units Weighing Units Weighing Units Weighing Units
g g g g g Grams Grams Grams Grams Grams
dwt Pennyweight
ct Carats
oz Ounces
ozt Troy ounces
UNIT1 Grains
t Taels (see note)
UNIT2 Mommes
UNIT3 Custom
1. Access the submenu.
2. .
3. or .
4. .
Unit Selection Unit Selection Unit Selection Unit Selection Unit Selection
The Unit Selection (SEL) submenu per-
mits the selection of weighing units for use
during operation. The balance can display
weights in every unit of measure listed in
table. The default setting is shown in bold
type.
NOTE: NOTE: NOTE: NOTE: NOTE:
If Taels is enabled, see next page before
exiting the menu.
To view or change the various weighing units:
1. Access the submenu.
2. .
3. or .
4. for next unit status.
5. Repeat steps 2 through 4 for each unit.
6. .
MENUS