EVS XTnano Version 10.03 - July 2010 Operation Manual - Manual (Page 79)

Issue
10.03.D XTnano – Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
72
9.10 ADDING & REPLACING CLIPS IN A
PLAYLIST
9.10.1 P
OSSIBLE
M
ETHODS FOR
A
DDING
C
LIPS
You can add clips to a playlist in different ways:
• Adding clips at the end of the current playlist without entering the Playlist Edit
mode.
See the section 9.10.2 ‘How to Quickly Add Clips to the Current Playlist’, on
page 72.
• Inserting clips before or after the clip selected in the loaded playlist.
See the section 9.10.3 ‘How to Insert Clips into a Playlist’, on page 72.
9.10.2 H
OW TO
Q
UICKLY
A
DD
C
LIPS TO THE
C
URRENT
P
LAYLIST
You can create a playlist very quickly. The experienced operator can include a clip
at the end of the playlist containing an action that happened seconds before the
playlist is played on air. To add clips quickly at the end of the current playlist, you
do not have to enter the Edit mode.
To add clips to the current playlist, proceed as follows:
1. Activate a playlist as the current playlist.
For more information, refer to the section 9.4.2 ‘How to Activate a Playlist’,
on page 62.
2. Recall the first clip for your playlist. For more information, refer to the
section 8.2.3 ‘Recalling a Clip’, on page 33.
3. Press ENTER on the Remote Panel.
The clip is added at the end of the current playlist.
4. Repeat as many times as necessary until the last clip is entered.
9.10.3 H
OW TO
I
NSERT
C
LIPS INTO A
P
LAYLIST
The following rules apply to the procedure below:
• You need to be in PGM/PRV mode to be able to use the TAKE key on the
Remote Panel to insert a clip.
• Depending on what is selected in the Setup menu, on page 4.1 - Insert in
Playlist setting (F5), the clip will be inserted before or after this selected
position.
To insert a clip into a playlist, proceed as follows: