EVS XTnano Version 10.03 - July 2010 Operation Manual - Manual (Page 88)

XTnano – Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
81
9.13 THE AUXILIARY AUDIO CLIP
9.13.1 I
NTRODUCTION
This option allows adding a new stereo audio track (for example. sport comments,
music, jingles, ambient sound) to the original video clips. This stereo audio track
is available on the PVW output and on analogue outputs 7/8 or on digital outputs
15/16. The selection of the track output is done via the Setup menu – Page 5.1 -
F5. The original audio tracks are still available on outputs 1/2 (3/4). The auxiliary
audio clip selected is always played back with normal speed (100%), whatever the
selected playback speed for the video.
When the playback of the playlist is not started from the beginning, the system
calculates the offset between the current position and the beginning of the
playlist, and applies the same offset to the Aux Clip, so that it can remain
synchronized with the playlist. If the duration of the Aux Clip is longer than the
playlist duration, the auxiliary audio clip keeps playing even after the video has
stopped. Otherwise, the audio clip ends itself before the end of the playlist, when
the audio clip reaches its OUT point.
9.13.2 H
OW TO
A
DD
/R
EMOVE AN
A
UXILIARY
A
UDIO
C
LIP TO A
P
LAYLIST
1. Make the Aux Clip button active by selecting a clip from the clip bank. This
can be done outside of the PLST EDIT mode, or in PLST EDIT mode with PRV
CTRL ON. You will see the Aux Clip option appearing in the secondary menu
on the LCD of the Remote Panel.
2. Then press MENU to call the secondary menu, then Aux Clip button (SHIFT +
B): the ID of the Aux Clip appears in the title bar of the Playlist screen (F10)
3. To remove the current auxiliary clip, load the auxiliary clip, call the secondary
menu by pressing MENU, then press CLEAR + SHIFT + (B) (Aux Clip) on the
Remote.