EVS XTnano Version 10.03 - July 2010 Operation Manual - Manual (Page 32)

XTnano – Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
25
• When a clip is played, it will not stop on the Short OUT point, but will continue
to play through the Short OUT point by the Post-Roll duration defined in the
Setup Menu.
• When a record train is played, the same will happen if the Record Train OUTs
parameter is set to “Freeze” in the Setup menu.
• When a playlist is played, the Post-Roll will apply only to the last clip of the
playlist.
6.1.2 O
PERATIONAL
M
ENU
Rst Cam Sync Prv
Cam A Cam B
CAM A/B
Rst Cam Sync Prv
Cam A Cam B
This parameter allows selecting the camera on the PGM output if PRV CTL is OFF
and on PRV output if PRV CTL is ON.
R
ST
C
AM
Rst Cam Sync Prv
Cam A Cam B
This function restores the position of cameras on the active channels: CAM A on
PGM1, CAM B on PRV.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode
will recall the record train, which was last used on that output. This
avoids too frequent uses of the Rst Cam function.
S
YNC
P
RV
Rst Cam Sync Prv
Cam A Cam B
This option allows the user to synchronize the PRV with the timecode and speed of
the PGM output.