EVS XTnano Version 10.03 - July 2010 Operation Manual User Manual
Page 12
XTnano – Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
5
Note
The operational buttons have PRIMARY and SECONDARY functions and
are divided into upper and lower sections. By pressing the SHIFT button
you gain access to the secondary functions.
1. F-keys and
small buttons
Multi-purpose keys
2. Soft keys
With LCD display, allow the operator to enter the Multicam
MENU system.
3. Lever
Initiates slow motion and playlist replay.
4. Jog dial
Used to accurately cue disk recorder.
5. Operational block 1
PLST
Initiates active playlist.
Loop
This option records the main output (PGM1) to the first
input (CAM A) of Multicam.
Browse
Used to browse through clips, playlists, cue points.
Insert
Used in playlist management to insert clips into a playlist.
IN
Sets Mark IN at the current position.
Goto IN
Goes to the defined Mark IN.
OUT
Sets Mark OUT at the current position.
Goto OUT
Goes to the defined Mark OUT.
TAKE
In PGM + PRV mode, pressing this button swaps cameras
on PGM and PRV monitors
In Multi-PGM mode, pressing this button toggles between
CAM selection and PGM selection modes.
In 2 PGM mode, when both PGMs are selected on the
Remote Panel, pressing this button swaps the content
loaded on PGM1 with the one loaded on PGM2 and vice-
versa.
In Playlist Edit mode, pressing this button inserts the clip
loaded on the PRV channel into current playlist.
Lever
Changes the lever range to secondary mode (see setup
menu for range selection).