EVS XTnano Version 10.03 - July 2010 Operation Manual - Manual (Page 56)

XTnano – Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
49
8.2.23 M
OVING AND
C
OPYING
C
LIPS
Copying and moving clips in the VGA are performed using the CUT, COPY and
PASTE functions.
G
ENERAL
P
RINCIPLES
• If the clipboard was filled using the CUT function, the original clip(s) is/are
deleted after being pasted to the new location.
• In CAM mode, only the selected camera of the clip is Cut/Copied/Pasted. In
CLIP mode, all camera angles of the clip are Cut/Copied.
• For the Paste function in CLIP mode, only the available camera locations
inside the destination clip will be pasted. If some camera angles already exist
for the destination clip, these will not be overwritten by the corresponding
camera in the clipboard.
• A “Cut and Paste” of a clip is equivalent to a “Move Clip”, meaning that any
reference to that clip inside playlists will be updated to the new location of
that clip. This is not the case when doing a “Copy and Paste”, then deleting
manually the original clip.
C
LIPBOARD
F
IELD
This area displays the content of the clipboard: clip number and the selected
camera(s) for a clip.
The rest of the line summarizes the available functions (COPY, CUT, PASTE, and
DELETE) and their keyboard shortcuts. These functions can also be called by
clicking on the corresponding area on this line.
CTL + X:CUT
This command is only applicable to clips.
1. Move the cursor to the clip/playlist to “cut” from the Clip screen.
2. Press CTRL + X on the keyboard or click on the corresponding area on the
screen.
The clip removed from the current location and copied to the clipboard.
CTL + C:COPY
1. Move the cursor to the clip/playlist to copy
2. Press CTRL + C on the keyboard or click on the corresponding area on the
screen.
The clip is copied to the clipboard.