EVS XSnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 52)

3. Multicam Configuration
3.1. Overview on User Interfaces
3.1.1. Introduction
Preliminary Remarks
Configuration as Initial Step
Prior to using Multicam, the operator should set all necessary parameters in the Multicam
Configuration window. If clips are stored with certain parameters and the operator wishes
to change the parameter values afterwards, those clips and playlists will not change.
Configuration with Caution
Most parameters are factory preset, and should not be modified without advice of qualified
EVS staff. Improper values for some parameters will prevent the proper operation of the
system.
Parameter Availability
Only the parameters or parameter values valid for the given server type, server chassis,
and active license codes are available for defining the various configurations.
General Comparison Between User Interfaces
You can configure the EVS server using one of the three available user interfaces:
• Multicam Configuration window in the server-based application
• Multicam Configuration window in the web-based interface
• Technical and Operational Setup menus in an EVS Remote Panel (if any)
The Multicam Configuration windows in the server-based and web-based interface are
almost identical.
In the Remote Panel, however, only the most used technical settings are available in the
Technical Setup menu, and all operational settings are available in the Operational Setup
menu.
XSnano Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 42