EVS XSnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 119)

The following screenshot shows the Net Name field on page 1 of the Network tab in the
server-based application in advanced mode when no SDTI network is available:
Net Name
Description Machine name on the SDTI network.
It is not mandatory. It can however be useful to easily identify
the servers running a given configuration, as it is tied to the
running configuration.
The Net Name will be displayed even if the SDTI code is not
valid.
Values The Net Name is user-defined and cannot exceed 8
characters.
Default Values By default, no Net Name is assigned.
3.5.3. Gigabit Ethernet Settings
Introduction
The Gigabit Ethernet settings specify the settings related to the Gigabit Ethernet
network. It allows the backup and transfer of the audio and video data without going
through the SDTI network.
The Gigabit connection is provided via the H3X or HCTX board. Its backplane is equipped
with two Gigabit Ethernet ports. The settings need to be defined on at least one port for the
server to be able to operate the Ethernet connection.
When the Gigabit module is not present on the H3X or HCTX board or when the Gigabit
connection has been lost, the first line of the Gigabit Ethernet settings will display the
message !Not detected!.
These fields are available in the following interfaces:
109 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B