EVS XSnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 150)

Default copy/move
Description Specifies whether the copy operations should be executed
preferably using the SDTI or the Gigabit network.
Values The value is forced to Gigabit for this parameter on an XSnano
server.
• Gigabit:
The copy operations are executed via the GigE interface.
Freeze on cue points
Description Specifies whether Multicam will freeze or not when it reaches
a cue point marked on the record train that is being played
back.
The Post-Roll parameter is not taken into account for this
functionality.
Values Yes / No
When playing record trains where cue points have been
marked, the playout freezes on the cue point if the parameter
is set to “Yes”. It plays through if the parameter is set to “No”.
Default value No
Protocol Receive page
Description Specifies on which page the clips created by protocols are
stored. When a page is full, clips are stored on the next page.
Only clips created on this page (and the other protocol pages if
the first page is full) are visible for protocols.
Values 1 to 10 (=0)
Default value 6
XSnano Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 140