EVS XSnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 147)

Automake clip for CAM A/B/C/D
Availability This parameter is only displayed in XSense configurations.
Introduction When creating clips, the clip corresponding to the camera on
which IN/OUT points have been marked are always saved. It
is possible to save automatically the same action on the other
cameras.
Only cameras letters applicable to the logical channels are
displayed.
Description Specifies that clips have to be created on the given camera (A,
B, C, D) even if no IN or OUT point has been marked on that
camera.
Values Yes / No
Default value Yes
Guardbands
Description Specifies the amount of A/V material that remains available
before and after a clip (called 'guardbands') when the clip is
created.
Values From 00s00fr to 60s00fr
Default Value 05s00fr
Default clip duration
Description Specifies the duration of clips created with only one reference
point (IN or OUT point).
Values Disable, or from 00s01fr to 4h.
When set to 'Disable', both IN and OUT points are required to
be able to create a clip.
The duration can be set:
• With second granularity up to 1 minute
• With minute granularity from 1 minute up to 4 hours.
Default value 04s00fr
137 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B