Garmin G1000 Quest Kodiak - Manual (Page 56)

Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 190-00590-01 Rev. B
SYSTEM OVERVIEW
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
44
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
44 Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
s
cheDUler
The G1000’s Scheduler feature can be used to enter and display reminder messages (e.g., “Change oil”,
“Switch fuel tanks”, “Overhaul”) in the Alerts Window on the PFD. Messages can be set to display based
on a specific date and time (event), once the message timer reaches zero (one-time; default setting), or
recurrently whenever the message timer reaches zero (periodic). Message timers set to periodic alerting
automatically reset to the original timer value once the message is displayed. When power is cycled,
messages are retained until deleted, and message timer countdown is restarted.
Figure 1-40 Scheduler (Utility Page)
Entering a scheduler message:
1) Select the AUX - Utility Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the first empty scheduler message naming field.
4) Use the FMS Knob to enter the message text to be displayed in the Alerts Window and press the ENT Key.
5) Press the ENT Key again or use the large FMS Knob to move the cursor to the field next to ‘Type’.
6) Turn the small FMS Knob to select set the message alert type:
• Event—Message issued at the specified date/time
• One-time—Message issued when the message timer reaches zero (default setting)
• Periodic—Message issued each time the message timer reaches zero
7) Press the ENT Key again or use the large FMS Knob to move the cursor to the next field.
8) For periodic and one-time message, use the FMS Knob to enter the timer value (HHH:MM:SS) from which to
countdown and press the ENT Key.