Flight management – Garmin G1000 Quest Kodiak User Manual
Page 170
Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
190-00590-01 Rev. B
158
FLIGHT MANAGEMENT
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
Airways may be displayed on the map at the pilot’s discretion using either a combination of AIRWAYS Softkey
presses, or menu selections using the MENU Key from the Navigation Map Page. The Airway range can also be
programmed to only display Airways on the MFD when the map range is at or below a specific number.
Displaying/removing airways:
1)
Select the MAP Softkey.
2)
Select the AIRWAYS Softkey. Both High and Low Altitude Airways are displayed (AIRWY ON).
3)
Select the softkey again to display Low Altitude Airways only (AIRWY LO).
4)
Select the softkey again to display High Altitude Airways only (AIRWY HI).
5)
Select the softkey again to remove High Altitude Airways. No airways are displayed (AIRWAYS).
Or
:
1)
Press the MENU Key with the Navigation Map Page displayed. The cursor flashes on the ‘Map Setup’ option.
2)
Press the ENT Key. The Map Setup Menu is displayed.
3)
Turn the small FMS Knob to select the ‘Airways’ group, and press the ENT Key.
4)
Turn the large FMS Knob to highlight the ‘AIRWAYS’ field.
5)
Turn the FMS Knob to select ‘Off’, ‘All’, ‘LO Only’, or ‘HI Only’, and press the ENT Key.
6)
Press the FMS Knob to return to the Navigation Map Page.
Figure 5-23 Navigation Map Setup Menu - AIRWAYS Setup
Low Altitude Airway Range
High Altitude Airway Range
Airway Display Selection
Off, All, LO Only, HI Only
The airway range is the maximum map range on which airways are displayed.
Selecting an airway range (LOW ALT AIRWAY or HI ALT AIRWAY):
1)
Press the MENU Key with the Navigation Map Page displayed. The cursor flashes on the ‘Map Setup’ option.
2)
Press the ENT Key. The Map Setup Menu is displayed.
3)
Select the ‘Airway’ group.
4)
Press the ENT Key.
5)
Highlight the ‘LOW ALT AIRWAY’ or ‘HI ALT AIRWAY’ range field.
6)
To change the range setting, turn the small FMS Knob to display the range list.
7)
Select the desired range using the small FMS Knob.
8)
Press the ENT Key.
9)
Press the FMS Knob to return to the Navigation Map Page.