Garmin G1000 Quest Kodiak - Manual (Page 441)

190-00590-01 Rev. B Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
429
APPENDIX A
GRS 77 Message Advisories (Cont.)
Alerts Window Message Comments
MANIFEST – GRS1 software
mismatch, communication halted.
The #1 AHRS has incorrect software installed. The G1000 system should be serviced.
MANIFEST – GRS2 software
mismatch, communication halted.
The #2 AHRS has incorrect software installed. The G1000 system should be serviced.
GMU 44 Message Advisories
Alerts Window Message Comments
HDG FAULT – AHRS1 magnetometer
fault has occurred. A fault has occurred in the #1 GMU 44. Heading is flagged as invalid. The AHRS uses
GPS for backup mode operation. The G1000 system should be serviced.
HDG FAULT – AHRS2 magnetometer
fault has occurred. A fault has occurred in the #2 GMU 44. Heading is flagged as invalid. The AHRS uses
GPS for backup mode operation. The G1000 system should be serviced.
MANIFEST – GMU1 software
mismatch, communication halted.
The GMU 44 has incorrect software installed. The G1000 system should be serviced.
MANIFEST – GMU2 software
mismatch, communication halted.
GDL 69A Message Advisories
Alerts Window Message Comments
GDL69 CONFIG – GDL 69 config
error. Config service req’d. GDL 69 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
GDL69 FAIL – GDL 69 has failed. A failure has been detected in the GDL 69. The receiver is unavailable. The G1000
system should be serviced
MANIFEST – GDL software mismatch,
communication halted.
The GDL 69 has incorrect software installed. The G1000 system should be serviced.
GDC 74A Message Advisories
Alerts Window Message Comments
ADC1 ALT EC – ADC1 altitude error
correction is unavailable.
GDC1 or GDC2 is reporting that the altitude error correction is unavailable.
ADC2 ALT EC – ADC2 altitude error
correction is unavailable.
ADC1 AS EC – ADC1 airspeed error
correction is unavailable.
GDC1 or GDC2 is reporting that the airspeed error correction is unavailable.
ADC2 AS EC – ADC2 airspeed error
correction is unavailable.
MANIFEST – GDC1 software
mismatch, communication halted.
The GDC 74B has incorrect software installed. The G1000 system should be serviced.
MANIFEST – GDC2 software
mismatch, communication halted.