beautypg.com

Setting the total fuel onboard alarm, Configuring my boat – Garmin GPSMAP 545s User Manual

Page 53

background image

GPSMAP 400/500 Series Owner’s Manual

47

Configuring the Chartplotter

Setting Weather Alarms

NOTE: You must have a subscription to XM WX Weather and

a connected Garmin XM WX weather receiver to view weather

information (

page 60

).

1. From the Home screen, select

Configure

>

Alarms

>

Weather

.

2. Turn the following alarms on or off: marine, tornado, severe

storm, flood, or flash flood.

Setting the Total Fuel Onboard Alarm

You can configure your chartplotter to sound an alarm when the total

amount of remaining onboard fuel reaches the specified level.
To receive fuel-level information, your unit must be connected to an

external fuel sensor, such as the Garmin GFS 10.

To enable the Total Fuel Onboard alarm and set the fuel

alarm level:

1. From the Home screen, select

Configure

>

Alarms

>

Fuel

>

Total Onboard

>

On

(or

Off

).

2. If you select

On, use the

Rocker

to indicate the fuel level at

which the alarm should sound.

Configuring My Boat

To configure settings for your boat, from the Home screen, select

Configure

>

My boat

.

Keel Offset—offset the surface reading for the depth of a keel,

making it possible to measure depth from the bottom of the keel

instead of from the transducer location. Enter a positive number to

offset for a keel. Enter a negative number to compensate for a large

vessel that may draw several feet of water.

To adjust the Keel Offset:

1. From the Home screen, select

Configure

>

My Boat

>

Keel

Offset

.

2. Use the

Rocker

to enter the measured distance from the

transducer location to the water line or to the keel of the boat.
• If you are measuring down to the keel (transducer installed at

the water line), enter a (+) positive number. This shows the

depth at the bottom of the keel.

• If you are measuring up to the water line (transducer installed

on the bottom of the keel), enter a (-) negative number. This

shows the depth at the surface.

3. Select

Done

to accept the number.