Garmin G1000 Mooney M20TN - Manual (Page 373)

Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 190-00647-01 Rev. B 362
AUTOMATIC FLIGHT CONTROL SYSTEM
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
CONTROL WHEEL STEERING
During autopilot operation, the aircraft may be hand-flown without disengaging the autopilot. Pressing and
holding the CWS Button disengages the pitch and roll servos from the flight control surfaces and allows the
aircraft to be hand-flown. At the same time, the flight director is synchronized to the aircraft attitude during
the maneuver. The ‘AP’ annunciation is temporarily replaced by ‘CWS’ in white for the duration of CWS
maneuvers.
In most scenarios, releasing the CWS Button reengages the autopilot with a new reference. Refer to the flight
director modes section for specific CWS behavior in each mode.
Figure 7-27 CWS Annunciation
Control Wheel Steering
DISENGAGING THE AUTOPILOT
The autopilot is manually disengaged by pushing the AP DISC Switch, GA Switch, TRIM ARM Switch, or the
AP Key on the MFD. Manual disengagement is indicated by a five-second flashing yellow ‘AP’ annunciation and
a two-second autopilot disconnect aural alert. After manual disengagement, the autopilot disconnect aural alert
may be cancelled by pushing the TRIM ARM or AP DISC Switch (AP DISC Switch also cancels the flashing
‘AP’ annunciation).
Figure 7-28 Manual Autopilot Disengagement
Automatic autopilot disengagement is indicated by a flashing red ‘AP’ annunciation and by the autopilot
disconnect aural alert, which continue until acknowledged by pushing the AP DISC or TRIM ARM Switch.
Automatic disengagement occurs due to:
• System failure
• Inability to compute default flight director modes
(FD also disengages automatically)
• Invalid sensor data
Figure 7-29 Automatic Autopilot Disengagement