Garmin G1000 Quest Kodiak - Manual (Page 473)

190-00590-03 Rev. A Garmin G1000 Pilot’s Guide for the Quest KODIAK 100
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
461
APPENDIX b
4) Press the YES Softkey. The navigation database is copied to the SD card in the bottom card slot of the MFD. A
prompt similar to Figure B-11 is displayed.
NOTE: During the synchronization process, version differences between navigation databases will exist
on the SD cards. This will result in the system displaying a ‘DB Mismatch’ alert for the standby navigation
databases until the database has finished copying.
Figure B-11 Active Navigation Database Prompt
5) Press the NO Softkey. The display now starts in normal mode. Since the database effective date is not yet valid,
it should not be loaded as the active database.
6) Press the ENT Key to acknowledge the startup screen.
7) Turn the large FMS Knob to select the AUX Page group on the MFD.
8) Turn the small FMS Knob to select the System Status Page.
9) If necessary, press the SYNC DBS Softkey to enable database synchronization (Figure B-2). A confirmation box
is displayed as shown in Figure B-12. If Database Synchronization has been enabled prior to this step, proceed
to step 11.
Figure B-12 Enable Database Synchronization Prompt
10) With YES highlighted, press the ENT Key.