Garmin G1000 Quest Kodiak - Manual (Page 471)

190-00590-03 Rev. A Garmin G1000 Pilot’s Guide for the Quest KODIAK 100
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
459
APPENDIX b
Loading the Jeppesen navigation database as the active navigation database:
NOTE: Loading the Jeppesen navigation database as the active database prior to its effective date will result
in the expiration date on the power-up screen and the effective date on the AUX-System Status Page being
displayed in yellow.
1) With the system OFF, insert the SD card containing the new navigation database version into the top card slot
of the display (PFD or MFD) to be updated (label of SD card facing left).
2) Turn the system ON. A prompt similar to the following is displayed in the upper left corner of the display:
Figure B-7 Standby Navigation Database Prompt
3) Press the NO Softkey to proceed to loading the active database.
4) A prompt similar to the following is displayed. Press the YES Softkey to update the active navigation
database.
Figure B-8 Active Navigation Database Prompt
5) After the update completes, the display starts in normal mode.
6) Turn the system OFF and remove the SD card from the top card slot.
7) Repeat steps 1 through 6 for the other displays (PFD or MFD).
8) Apply power to the system and press the ENT Key to acknowledge the startup screen.
9) Turn the large FMS Knob to select the AUX Page group on the MFD.
10) Turn the small FMS Knob to select the System Status Page.