Garmin G1000 Quest Kodiak - Manual (Page 472)

190-00590-03 Rev. A Garmin G1000 Pilot’s Guide for the Quest KODIAK 100
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
460
APPENDIX b
11) Press the Display Database Selection Softkey to show active navigation database information for each display
(MFD1 DB, PFD1 DB, PFD2 DB). Verify the correct active navigation database cycle information is shown for
each display. Figure B-9 shows the active navigation database information for the MFD.
NOTE: After the navigation database is loaded or copied, the top SD card may be removed.
Figure B-9 Check Database Cycle Number
Loading the Jeppesen navigation database as the standby navigation database:
1) With the system OFF, insert the SD card containing the new navigation database version into the top card slot
of the MFD.
2) Verify that an SD card is inserted in the bottom slot of the PFDs and MFD.
3) Turn the system ON. A prompt similar to Figure B-10 is displayed.
Figure B-10 Standby Navigation Database Prompt