Panasonic SDR-S10 - Manual (Page 35)

35
VQT1E14
Setup
≥ The 24-hour system is used to
display the time.
3
Press the cursor button in the
centre to enter the selection.
≥ The clock function starts at
[00] seconds when the cursor
button in the centre is pressed.
≥ After pressing the MENU button to
finish the setting, check the date
and time display.
∫ Changing the date and time
display style
Press the MENU button, then select
[SETUP]
# [DATE/TIME] # desired
display style and then press the
cursor button in the centre.
∫ Changing the display style
Press the MENU button, then select
[SETUP]
# [DATE FORMAT] #
desired display style and press the
cursor button in the centre.
≥ The date and time function are driven
by a built-in lithium battery.
≥ Make sure to check the time before
recording.
If the time display becomes [- -], the
built-in lithium battery has run down. Use
the following steps to charge the battery.
When you turn on the power for the first
time after charging, a message asking
you to set the date and time will appear.
Select [YES] and set the date and time.
To recharge the built-in lithium battery
Connect the AC adaptor or attach the
battery to the unit and the built-in lithium
battery will be recharged. Leave the unit
as it is for approx. 24 hours and the
battery will save the date and time for
approx. 6 months. (The battery will still
be recharged even if the mode dial is set
to OFF.)
(For Australia)
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2007.12.15
[M/D/Y] 12.15.2007
[D/M/Y] 15.12.2007
15.12.2007 15.12.2007 15:30
WARNING
THE LITHIUM BATTERY IN THIS
EQUIPMENT MUST ONLY BE
REPLACED BY QUALIFIED
PERSONNEL. WHEN NECESSARY,
CONTACT YOUR LOCAL
PANASONIC SUPPLIER.
WARNING
THE LITHIUM BATTERY IN THIS
UNIT MUST ONLY BE REPLACED
BY QUALIFIED PERSONNEL. IF
THIS IS NECESSARY, CONTACT
THE PANASONIC CUSTOMER
CARE CENTRE ON 132600 FOR
YOUR NEAREST AUTHORIZED
SERVICE CENTRE.
VQT1E14(EB_GC_ENG).book 35 ページ ２００７年２月２８日 水曜日 午後２時２３分