Panasonic SDR-S10 - Manual (Page 24)

24
VQT1E14
Setup
The power can be turned on and off with
the LCD monitor when the mode dial is
set to
or .
∫ To turn on the power
Open the LCD monitor.
The status indicator lights and the power
turns on.
∫ To turn off the power
Close the LCD monitor.
The status indicator goes off and the
power turns off. (If [QUICK START] is set
to [ON], the unit goes into quick start
standby mode and the status indicator
flashes green.)
≥ The power will not turn off while
recording motion pictures even if the
LCD monitor is closed.
When quick start is ON the battery power
is still being consumed, even when the
LCD monitor is closed.
This unit will resume recording/pause
mode about 1.7 seconds after the LCD
monitor is reopened.
≥ When in quick start standby mode,
about half of the power used in
recording pause mode is being
consumed, so the recording time
will be reduced.
≥ This is only activated in the
following cases.
jWhile using the battery
When the mode dial is set to or
and an SD card is inserted.
jWhile using the AC adaptor
When the mode dial is set to or
, quick start can be used even if
an SD card is not inserted.
1
Press the MENU button then
select [SETUP]
#
[QUICK START] # [ON] and
then press the cursor button
in the centre.
How to turn the power on
and off with the LCD
monitor
Set the mode dial to OFF when the
unit is not being used.
Quick start
VQT1E14(EB_GC_ENG).book 24 ページ ２００７年２月２８日 水曜日 午後２時２３分