RIDGID micro CA-300 - Manual (Page 21)

micro CA-300 Inspection Camera
19
1. Set up charger according to the Charger
Inspection and Set Up section.
2. The charger conducts a 1‑second life test
during which the LED blinks from red to
green. The charger then goes into stand‑
by mode in which the LED is OFF.
3. With dry hands, insert the battery pack
onto the charger. The battery pack will
begin charging automatically. While the
battery is charging, the red LED will glow
solid.
4. When the battery is fully charged, the
green LED glows solid. Remove the bat‑
tery. Once the battery is charged, it may
remain on the charger until it is ready to
be used. There is no risk of over‑charging
the battery. When the battery has been
fully charged, the charger automatically
switches to retention charging.
5. With dry hands, unplug the charger from
the outlet once charging is complete.
Cleaning Instructions
WARNING
Unplug the charger before cleaning. Do not
use any water or chemicals to clean charger
or batteries to reduce the risk of electrical
shock.
1. If present, remove battery from charger.
2. Remove any dirt or grease from the ex‑
terior of the charger and battery with a
cloth or soft non‑metallic brush.
Accessories
WARNING
To reduce the risk of serious injury, only use
accessories specifically designed and rec‑
ommended for use with the RIDGID Li‑Ion
Battery Charger such as those listed below.
Other Accessories suitable for use with oth‑
er tools may be hazardous when used with
the RIDGID Li‑Ion Battery Charger.
Catalog
No. Description
37088 micro CA‑300 Charger
37083 micro CA‑300 3.7V Li‑Ion Battery
30758 microEXPLORER Charger
30198 microEXPLORER 3.7V Li‑Ion
Battery
Further information on accessories specific to the
charger can be found in the RIDGID Catalog and
online at www.RIDGID.com or www.RIDGID.eu.
Storage
Store the charger and the batteries in a dry,
secured, locked area that is out of reach of
children and people not familiar with proper
charger operation.
The batteries and charger should be pro‑
tected against hard impacts, moisture and
humidity, dust and dirt, extreme high and
low temperatures and chemical solutions
and vapors.
Long‑term storage in temperatures above
104°F (40°C) can permanently reduce the ca‑
pacity of the batteries.
Service and Repair
WARNING
Improper service or repair can make the
RIDGID micro CA‑300 Inspection Camera
unsafe to operate.
There are no user‑serviceable parts for this
charger or batteries. Do not attempt to open
charger or battery cases, charge individual
battery cells or clean internal components.
Service and repair of the charger must be
performed by a RIDGID Independent Author‑
ized Service Center.
For information on your nearest RIDGID In‑
depen dent Service Center or any service or
repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu
to find your local RIDGID contact point.
• Contact RIDGID Technical Services De‑
partment at rtctechservices@emerson.
com, or in the U.S. and Canada call (800)
519‑3456.