RIDGID micro CA-300 - Manual (Page 19)

micro CA-300 Inspection Camera
17
• Do not carry charger by power cord.
Reduces the risk of electrical shock.
• The RIDGID Battery Charger is not
intended for use by persons (includ‑
ing children) with reduced physical,
sensory or mental capabilities, or lack
of experience and knowledge, un‑
less they have been given supervision
or instruction concerning use of the
RIDGID Battery Charger by a person
responsible for their safety.
• Keep children and by-standers away
while operating equipment. Distrac‑
tions can cause you to lose control.
• Have your equipment (including
power supply cord) serviced by a
qualified repair person using only
identical replacement parts. If the
equipment is damaged, it must be
replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
This will ensure that the safety of the
tool is maintained.
Battery Safety
• Properly dispose of the battery. Ex po‑
sure to high temperatures can cause the
battery to explode, so do not dispose of
in a fire. Place tape over the terminals
to prevent direct contact with other ob‑
jects. Some countries have regulations
concerning battery disposal. Please fol‑
low all applicable regulations.
• Do not insert the battery with cracked
case into charger. Damaged batteries
increase the risk of electrical shock.
• Never disassemble battery. There are
no user‑serviceable parts inside the
battery. Disassembling batteries may
cause electrical shock or personal in‑
jury.
• Avoid contact with fluids oozing from
defective battery. Fluids may cause
burns or skin irritation. Thoroughly rinse
with water in case of accidental contact
with fluid. Consult doctor if fluid comes
into contact with eyes.
Description and
Specifications
Description
The RIDGID Battery Charger (Catalog Num‑
ber 37088), when used with appropriate bat‑
teries (Catalog Number 37083) listed in the
Accessories section, is designed to charge a
3.7V Li‑Ion RIDGID battery in approximately
4 ‑ 5 hours. This charger requires no adjust‑
ments.
Figure 21 - Battery and Charger
Specifications
Input.............................. 100 ‑ 240 VAC, 50 / 60 Hz
Output.......................... 4.2V DC
Battery Type................ 3.7V Li‑Ion
Battery Capacity........ 4.2Ah
Input Current ............ 0.3A (AC) / 1A (DC)
Weight.......................... 0.4 lbs (0,02kg)
Charging Time........... 4 to 5 Hrs
Cooling......................... Passive Convection
Cooling (No Fan)