Xerox 155 - Manual (Page 60)

Controller requirements and specifications
5-8 Installation Planning Guide
Controller hardware specifications and requirements summary
The following tables summarize the specifications and electrical
requirements of your controller hardware components.
For a summary of printer hardware specifications and
requirements, refer to the “Printer specifications and
requirements” chapter of this guide. Contact your local Xerox
representative if you have questions not specifically addressed
in this guide.
Table 5-2. Sun Blade 1000/2000 specifications
Device
Dimensions (depth,
width, height)
Weight
Heat
dissipation Power requirements
Cable lengths
Stand d=35.5 in / 90.2 cm
w=30 in / 76.2 cm
h=38.25 in / 97.2 cm
NOTE: Add 3 in /
7.62 cm to stand’s
depth with channel
interface board and
channel cable
connector box.
195 lbs /
88.6 kg --- --- ---
Processor d=25 in / 63.5 cm
w=10 in / 25.4 cm
h=17.75 in / 45.1 cm
70 lbs /
31.8 kg 1,100 BTU
per hour 60 Hz:
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
50 Hz:
100 to 240 VAC,
15 amp, 0.4 KVA
Power: 8 ft. /
2.4 m
Interface to
printer:
20 ft. / 6.1 m
usable length
Monitor d=10 in / 25.4 cm
w=17.5 in / 44.5 cm
h=18.5 in / 47 cm
18 lbs /
8.2 kg 408 BTU
per hour 100-120 ~ VAC,
1 phase, 50-60 Hz,
3.0 amp, 0.4 KVA
200-240 ~ VAC,
1 phase, 50-60 Hz,
2.0 amp, 0.4 KVA
Video cable to
processor:
46 in / 1.17 m
Quarter-inch
cartridge
tape drive W=7.5 in / 19 cm
H=2.7 in / 7 cm
D=13 in / 33 cm
8.4 lbs /
3.8 kg --- 100-240 VAC,
47-63 Hz,
max. 850 ma - 1.45
amp SCSI cable to
processor or
additional SCSI
device:
2.62 ft / 0.8 m
18/36 track
cartridge
tape drive
(optional) W= 8.54 in / 21.7 cm
H= 5.39 in / 13.7 cm
D= 21.9 in / 55.6 cm
31 lbs /
13.4 kg --- 88-264 VAC,
48-62 Hz,
max. 35 amp SCSI cable to
processor or
additional SCSI
device:
16.4 ft / 5 m,
32.8 ft / 10 m, and
65.6 ft / 20 m