Xerox 155 - Manual (Page 105)

Installation
Installation Planning Guide 8-3
• Have your operators available for training.
Refer to the installation planning checklist in the “Preparing for
installation” chapter of this guide for a complete list of
responsibilities.
Defining the printer to the host
Prior to installation of the printing system, your host system must
be configured to communicate with the Xerox DocuPrint 100/
115/135/155/180 EPS. This requires defining several parameters
to your host. The required information and configuration
procedures differ according to your connectivity type (channel or
TCP/IP), and your host environment. You will need to provide
these parameters to your Xerox representative on installation
day.
Software licensing
When you purchase a Xerox DocuPrint 100/115/135/155/180
EPS, you receive a license to use the operating system software.
This license is enabled by entering a 20-character alphanumeric
string at the controller. Your Xerox or service representative
obtains this license string for you and enters it when your printing
system is installed.
Ongoing maintenance
After the installation of your printing system, there are a few
ongoing tasks that must be performed. These tasks may include
the following:
• Maintaining an adequate inventory of consumable supplies
• Overseeing routine maintenance and meter reporting
• Arranging for additional operator training
• Ordering additional fonts
• Ordering additional documentation
• Placing service calls for hardware problems
• Obtaining assistance in solving software-related problems