ZyXEL Communications Prestige 314 PLUS - Manual (Page 42)

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
2-14 Hardware Installation & Initial Setup
2.9 WAN Setup
This section describes how to configure the WAN using Menu 2 – WAN Setup. From the main menu, enter
2 to display menu 2.
ZyXEL recommends you configure this menu even if your ISP does not require
MAC address authentication.
Figure 2-9 Menu 2 — WAN Setup
The MAC address field allows users to configure the WAN port's MAC Address by either using the factory
default or cloning the MAC address from a workstation on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
Table 2-8 WAN Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
MAC Address
Assigned By Press the [SPACE BAR] to choose one of two methods to assign a
MAC Address. Choose Factory Default to select the factory assigned
default MAC Address. Choose IP Address attached on LAN to use
the MAC Address of that workstation whose IP you give in the
following field.
IP Address
attached on
LAN
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle