ZyXEL Communications Prestige 314 PLUS User Manual

Page 175

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch

Firmware and Configuration Maintenance

12-13

Figure 12-14 Telnet Into Menu 24.7.2 — System Maintenance

To upload the firmware and the configuration file, follow these examples:

FTP File Upload Command from the DOS Prompt Example

Step 1. Launch the FTP client on your computer.

Step 2. Enter “open”, followed by a space and the IP address of your Prestige.

Step 3. Press [ENTER] when prompted for a username.

Step 4. Enter your password as requested (the default is “1234”).

Step 5. Enter “bin” to set transfer mode to binary.

Step 6. Use “put” to transfer files from the computer to the Prestige, for example, put firmware.bin ras

transfers the firmware on your computer (firmware.bin) to the Prestige and renames it “ras”.
Similarly put config.rom rom-0 transfers the configuration file on your computer (config.rom) to
the Prestige and renames it “rom-0”. Likewise get rom-0 config.rom transfers the configuration
file on the Prestige to your computer and renames it “config.rom.” See earlier in this chapter for
more information on filename conventions.

Step 7. Enter “quit” to exit the ftp prompt.

Menu 24.7.2 - System Maintenance - Upload System Configuration File

To upload the system configuration file, follow the procedure below:

1. Launch the FTP client on your workstation.

2. Type "open" and the IP address of your system. Then type "root" and

SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"

is the name of your system configuration file on your workstation, which

will be transferred to the "rom-0" file on the system.

4. The system reboots automatically after the upload system configuration

file process is complete.

For details on FTP commands, please consult the documentation of your FTP

client program. For details on uploading system firmware using TFTP (note

that you must remain on this menu to upload system firmware using TFTP),

please see your manual.

Press ENTER to Exit: