ZyXEL Communications Prestige 314 PLUS - Manual (Page 30)

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
2-2 Hardware Installation & Initial Setup
LED FUNCTION COLOR STATUS MEANING
Off The WAN Link is not ready, or has failed.
On The WAN Link is ok.
WAN WAN Green
Flashing The 10/100M WAN link is sending/receiving
packets.
2.2 Prestige Rear Panel and Connections
The following figure shows the rear panel of your Prestige and the related connections.
Figure 2-2 Prestige Rear Panel Connections
Table 2-2Prestige Rear Panel Connections
CONNECTION DESCRIPTION AND FUNCTION
Power 12VDC This supplies the power to the unit. Connect the supplied power adaptor to the
wall outlet and insert the small plug from the power adaptor to this socket.
Reset This button resets the unit. Refer to section 2.7.1 for details on how to reset the
unit.
LAN 10/100M These auto-sensing LAN ports are used to connect the Prestige to local
computers or to an external hub. All LAN ports are auto-sensing. This means that
these ports automatically adjust according to the type of cable, eg Straight-
through Ethernet cable or Crossover Ethernet cable.
Console This port is used for configuration and administration of the Prestige. Connect
your administration computer to this port via an RS-232 cable.
WAN 10/100M Connect your Cable/DSL modem to this port.
F.G. Ground the Prestige by connecting a grounded wire to the Frame Ground (F.G)
terminal.