ZyXEL Communications Prestige 314 PLUS - Manual (Page 178)

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
12-16 Firmware and Configuration Maintenance
Figure 12-16 Menu 24.7.1 as seen using the Console Port
Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.
Example Xmodem Firmware Upload Using HyperTerminal
Click Transfer, then Send File to display the following screen.
Figure 12-17 Example Xmodem Upload
After the firmware upload process has completed, the Prestige will automatically restart.
Menu 24.7.1 - System Maintenance - Upload Router Firmware
To upload router firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning: Proceeding with the upload will erase the current router
firmware.
Do You Wish To Proceed:(Y/N)
Type the firmware file’s
location, or click Browse to
look for it.
Choose the Xmodem
protocol.
Then click Send.