Xerox 480cx - Manual (Page 93)

Configuring Automatic Dialing Features 3-17
3
Note: If you assign a name to the number, the name will appear in the
display whenever you press the One-Touch button.
4 Press the Start/Enter button when the name appears correctly or
without entering a name.
The display prompts you to press another One-Touch button.
5 To assign another One-Touch number, press the desired One-Touch
button and repeat steps 2 through this step.
Or
To return to Standby mode, press the Stop button.
Dialing a One-Touch Number
1 Press the One-Touch button (0-20) to which you assigned the number
you wish to dial.
The number is automatically dialed. If a document is loaded into the
Automatic Document Feeder, the WorkCentre 480cx will begin
transmission of the document after the remote machine answers.
Using the One-Touch Address Label Sheet
A One-Touch label sheet is included with your machine. As you store
numbers in One-Touch dial buttons, make a note of the numbers on the
label to remind you which number is stored in each position.
Print the 480cx User Guide