beautypg.com

Choosing a connection method, Connecting via ethernet (recommended) – Xerox Color Printer Phaser 6280 User Manual

Page 33

background image

Choosing a Connection Method

Phaser® 6280 Printer

33

Choosing a Connection Method

Connect the printer via Ethernet or USB. A USB connection is a direct connection and is not
used for networking. An Ethernet connection is used for networking. Hardware and cabling
requirements vary for the different connection methods. Cabling and hardware are
generally not included with your printer and must be purchased separately.This section
includes:

Connecting via Ethernet (Recommended)

on page 33

Connecting via USB

on page 34

Connecting via Ethernet (Recommended)

Ethernet can be used for one or more computers. It supports many printers and systems on
an Ethernet network. An Ethernet connection is recommended because it is faster than a
USB connection. It also allows you direct access to CentreWare Internet Services (IS). The
CentreWare IS web interface enables you to manage, configure, and monitor networked
printers from your desktop. To reach CentreWare Internet Services, see

Starting

CentreWare IS

on page 145.

Network Connection

Depending on your particular setup, the following hardware and cabling is required for
Ethernet.

If you are connecting to one computer, an Ethernet RJ-45 crossover cable is required.

If you are connecting to one or more computers with an Ethernet hub, or cable or DSL
router, two or more twisted-pair (category 5/RJ-45) cables are required. (One cable for
each device.)

If you are connecting to one or more computers with a hub, connect the computer to the
hub with one cable, and then connect the printer to the hub with the second cable.
Connect to any port on the hub except the uplink port.

See also:

Configuring the Network Address

on page 35

Installing the Printer Drivers

on page 39