beautypg.com

Xerox Color Printer Phaser 6280 User Manual

Page 147

background image

Managing the Printer

Phaser® 6280 Printer

148

Commands That Can Be Used in E-mail Text

Use each command according to the following rules.

Prefix all commands with “#”, and specify the #Password command at the top of the
e-mail.

Command lines without “#” are ignored.

Write one command on each line and separate each command and parameter with a
space or a tab.

When the same command is written two or more times in one e-mail, the second and
subsequent commands are ignored.

Example of Commands

1. When the read only password is “ronly”, and to check the printer status:

#Password ronly

#Status

2. When the full access password is “admin”, and to set the recipient e-mail address to

[email protected]”:

#Password admin

#SetMsgAddr [email protected]

3. When the full access password is “admin”, and to set the recipient e-mail address to

[email protected]”, then confirm the setting result on the network settings list:

#Password admin

#SetMsgAddr [email protected]

#NetworkInfo

Note:

Describe the “#SetMsgAddr” command before the “#NetworkInfo” command. If

they are written in reverse, the information retrieved by the “#NetworkInfo” command
and the result of executing the “#SetMsgAddr” command may differ.

Command

Parameter

Description

#Password

Password

Use this command at the top of the e-mail when a password for
read only or full access is set. You can omit this command when
the password is not set.

#NetworkInfo

Set this when you want to check information on the network
settings list.

#Status

Set this when you want to check the printer status.

#SetMsgAddr

Recipient E-mail
address

Use this command to specify the e-mail address to which e-mail
reports are sent to. This command can only be used when the
full access password is specified by the #Password command.