Zoom RT-223 - Manual (Page 59)

Using Effects (Effect Mode)
ZOOM RT-223 59
When store was selected, the current patch will be
stored in this patch number.
When swap was selected, the current patch will be
swapped with the patch in this patch number.
5.
To carry out the process, press the
[INSERT/COPY] key.
Store, swap, or factory initialize is carried out,
and the patch select screen appears again. If you
press the [EXIT] key instead of the [INSERT/
COPY] key, the respective process is canceled.
Assigning a name to an
effect patch
To give a name to a patch of the COMP EQ effect
or REVERB effect, proceed as follows.
1.
From the COMP EQ effect or
REVERB effect patch select screen,
select the patch whose name you
want to change.
The patch name/patch number are shown.
2.
Press the [EDIT] key.
The patch edit screen appears. The display shows
the effect type.
3.
Use the cursor left/right keys to
bring up the indication "PATNAME"
on the display.
After a while, the name of the current patch
appears. The currently selected character of the
patch name flashes.
4.
Use the cursor left/right keys to
move the cursor position, and use
the VALUE [+]/[-] keys to select the
character.
For information on available characters, see page
33.
5.
Repeat step 4 until the name is
complete.
6.
When name input is completed,
press the [EXIT] key.
The patch select screen appears again. Press the
[EXIT] key once more to terminate effect mode.
NOTE
If you switch to another patch without
storing the edited patch first, the edit
contents will be lost. For information on
how to store a patch, see the previous
section.
MIDHALL
MIDHALL
RT223(E).fm 59 ページ ２００５年５月２６日 木曜日 午後１２時３分