Zoom RT-223 - Manual (Page 32)

ZOOM RT-223 32
Editing a Pattern
This section explains how to edit patterns.
Copying a pattern/
Returning a pattern to the
factory default condition
You can copy the currently selected pattern to
another position. This is useful to change only a
part of a pattern, such as changing the bass track
phrasing while keeping the drum track.
Patterns that were preprogrammed at the factory
(patterns 0 - 439) can be returned to their original
condition by the copy process described below.
NOTE
When the copy is executed, the existing
contents of the pattern selected as copy target
will be erased. Use this function with care.
1.
Press the [PATTERN] key.
The RT-223 goes into pattern mode, and the
pattern selection screen appears.
2.
Use the VALUE [+]/[-] keys to select
the pattern to use as copy source.
3.
Press the [INSERT/COPY] key.
The [INSERT/COPY] key flashes and the current
pattern is selected as the copy source.
4.
Use the VALUE [+]/[-] keys to select
the pattern to be used as copy
target.
HINT
When you select an empty pattern, the
indication “E” appears to the right of the
pattern number.
To return one of the factory preprogrammed
patterns (0 - 439) to the original condition, select
the same number as copy source and copy target
(the indication “COPY” appears on the display).
Then proceed to step 5.
5.
To execute the copy, press the
[INSERT/COPY] key.
• When you have selected an empty
pattern as copy target
The copy is carried out when you press the
[INSERT/COPY] key.
• When you have selected an existing
pattern as copy target
The indication “REPLACE” appears on the
display when you press the [INSERT/COPY]
key. To execute the copy, press the [INSERT/
COPY] key once more.
• When you have selected the same
pattern as copy source and copy target
The indications “FACTORY” and “REVERT”
appear alternately on the display when you
press the [INSERT/COPY] key. To execute the
TO 500E
Copy target pattern number
RT223(E).fm 32 ページ ２００５年５月２６日 木曜日 午後１２時３分