Zoom RT-223 - Manual (Page 30)

Entering Patterns Using Step Input
ZOOM RT-223 30
3.
Use the VALUE [+]/[-] keys to select
the quantize value (step length).
For information on quantize values, see page 23.
4.
Press the [FUNCTION] key once
more.
The quantize value is set, and the unit returns to
pattern mode.
5.
Press the REC [ O ] key.
The display changes as follows, and step input
becomes possible.
6.
Press the left or right cursor key.
The display changes as follows. Here you can set
the duration value.
The following settings for note duration are
available.
1 - 8 .............. Quarter note x 1 - 8
3/2 ................ Dotted quarter note
3/4 ................ Dotted eighth note
1/2 ................ Eighth note
1/3 ................ Eighth triplet note
1/4 ................ Sixteenth note
1/6 ................ Sixteenth triplet note
1/8 ................ Thirty-second note
7.
Use the cursor keys to select the
duration value.
After a while, the screen of step 5 appears again.
8.
To enter a note, press the pad for
the pitch, and then press the
[REPEAT/STEP] key.
The note is entered, and the input position
advances by one step. The sound duration will be
as specified earlier. You can check the current
position in the pattern on the display (measure/
beat/tick).
NOTE
If the entered duration exceeds the pattern
length, the note will continue until the end
of the pattern.
9.
To advance to the next step, press
the [REPEAT/STEP] key.
If you press the [REPEAT/STEP] key without
pressing a pad, the position advances by one step
without note entry.
001-01
00
D=1/2
Pad
RT223(E).fm 30 ページ ２００５年５月２６日 木曜日 午後１２時３分