Xerox 4110 - Manual (Page 9)

Xerox 4590 EPS/4110 EPS System Administration Guide 1-5
1. Overview
2. Switch off the main power switch on the back of the machine.
3. From the DocuSP Controller window, select
[System:
Shutdown]
to shut down the DocuSP Controller.
4. At the machine, switch the main power switch on the back of
the machine to on.
5. Open the power switch cover at the front of the machine and
press the power switch to the on [
| ] position. Make sure to wait
until the machine is fully up before proceeding to the next step.
6. On the DocuSP Controller, press the power on/off button and,
once the Controller is up, log on as System Administrator.
Power Saver mode
The machine is installed with a Power Saver feature that will
automatically cut off the electricity to the machine if no print data is
received for a certain duration.
The Power Saver feature has two modes: a Low Power mode and
a Sleep mode. If the machine is left unused for a preset period of
time, the machine enters the Low Power mode. The machine then
enters the Sleep mode if a further preset time elapses.
Low Power mode
(Power consumption: 225W)
In this mode, the power to the UI and fuser unit is lowered to save
power. The display goes out, and the
Power Saver
button on the
Control Panel lights. To use the machine, press the
Power Saver
button. The
Power Saver
button goes out to indicate that the
Power Saver feature is canceled.
Sleep mode
(Power consumption: 15W)
In this mode, the power is lowered to 15 watts and the fuser
switches off. The display goes out, and the
Power Saver
button
on the Control Panel lights. To use the machine, press the
Power
Saver
button. The
Power Saver
button goes out to indicate that
the Power Saver feature is canceled.