Xerox 4110 - Manual (Page 44)

Xerox 4590 EPS/4110 EPS System Administration Guide 4-26
4. Setups
3. Select
Paper Size
or
Paper Type
.
Paper Size
Standard-sized paper that is loaded into trays 3, 4, 6, and 7 is
automatically detected. However, when a nonstandard size is
loaded, it is necessary to specify the width and height.
KEY POINT:
Depending on the paper size, the guide lever
may not fit, and this may cause paper jams or other errors.
Tray detection may also not be possible. In such cases, use
tray 5 (Bypass Tray).
NOTE: Trays 1 and 2 are preset at manufacturing at size 8.5 x
11 inch (A4); therefore, the paper size for these two trays
cannot be changed on this screen.
Paper Type
The Paper Type feature is discussed on the following pages.
4. When selecting
Paper Size
, select
Auto Size Detect
or
Variable Size
.
KEY POINT:
Remember, you cannot select or set the paper
size for trays 1 and 2.
a. When
Variable Size
is selected, enter the paper size using
, , W , and X.