Yamaha Professional Audio Workstation AW4416 - Manual (Page 383)

TRACK screen
— Reference Guide
95
Stereo page
Playing or erasing the stereo track
[Function]
Play back the stereo track, or erase the
recorded contents.
[Key operation]
• [TRACK] key → [F3] (Stereo) key
• Repeatedly press the [TRACK] key until
the screen shown at the right appears.
[Mouse operation]
M button → TRAC button → Stereo tab
[Screen functions]
A M (mute) button
Use this button to switch muting on (●) or off
(O) for the stereo track. When muting is off, the
output of the stereo track will be assigned to
monitor channels 1/2. (Normally muting is on.)
When you play back the song in this state, the
stereo track can be monitored via monitor chan-
nels 1/2 → stereo bus. (At this time, tracks 1–16
will be forcibly muted.) When you turn muting
on for the stereo track, tracks 1–16 will return to
their previous status.
Tip!
For details on recording/playing the stereo
track, refer to Operation Guide “Chapter 5.
Recording on the AW4416.”
B Track view
Continuous audio data in the stereo track is dis-
played as a bar graph. The symbols displayed
below the track view indicate locate points and
markers at those locations. The following types
of symbols are displayed.
• S.........................Start point
• E.........................End point
• I .........................In point
• O........................Out point
• A ........................A point
• B ........................B point
• 1–99...................Markers 1–99
C Current position
The vertical line in the frame indicates the
approximate current position. The small sym-
bols beneath the frame indicates the approxi-
mate location of the locate points.
D STEREO OUT
This meter indicates the output level of the ste-
reo output channel. The pre/post-fader position
can be selected in the HOME screen Omni/ST
page.
E ST TRACK ERASE (stereo track erase)
button
If you move the cursor to this button and press
the [ENTER] key, the recorded contents of the
stereo track will be erased.
The stereo track is an L/R pair and has only
one region. If you re-record a previous
recording on the stereo track, the previously-
recorded content will be erased. (However,
you can use the [UNDO] key to return to the
previous state.)
1 5 2
3
4