Yamaha Professional Audio Workstation AW4416 - Manual (Page 274)

Chapter17—Mastering
— Operation Guide
259
Writing the master
Here’s how to use the mastering function to write the stereo track data to CD-R/
RW media.
1. Press the [MASTERING] key.
The MASTERING screen will appear in the display.
2. Hold down the [SHIFT] key and press the [F2] key (CD UNLOAD).
The tray of the CD-RW drive will open.
3. Place a CD-R/RW disc on the tray. Then hold down [SHIFT] and press the
[F1] key (CD LOAD).
The tray will close.
4. Use the [DATA/JOG] dial to select the SCSI ID number of the AW4416’s
internal CD-RW drive, and press the [ENTER] key.
• In the MASTERING screen, you can access all stereo tracks (44.1 kHz sam-
pling frequency) saved on the internal hard disk. Thus, it is not necessary that
the stereo track be part of the current song.
• However, the mastering function cannot be used if the current song has a sam-
pling frequency of 48 kHz. In this case, you must load a 44.1 kHz song before
you begin the mastering procedure.