Zebra Technologies Z6Mplus - Manual (Page 88)

70 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Configuration
Configuration and Calibration LCD Displays
WEB S.
MEDIA S.
RIBBON S.
TAKE LABEL
MEDIA LED
RIBBON LED These parameters are automatically set during the calibration procedure. They should
be changed only by a qualified service technician. See the Maintenance Manual for
more information on these parameters.
Press PLUS (+) repeatedly to skip these parameters.
LCD ADJUST LCD Display Adjustment
This parameter allows you to adjust the brightness of your display if your display is
difficult to read.
Range: 0 to 19
1. Press SELECT to select the parameter.
2. Press MINUS (–) to decrease the value (reduce brightness).
3. Press PLUS (+) to increase the value (increase brightness).
4. Press SELECT to accept any changes and deselect the parameter.
FORMAT
CONVERT
Format Convert
The Format Convert setting is used when upgrading from a printer of lower resolution
to a printer of higher resolution and the user does not wish to modify their formats.
Example: If your original formats were written for a 150 dpi printer and your new
printer is 300 dpi, you would choose 150–>300.
Default: None
Selections: None, 150–>300, 150–>600, 200–>600, 300–>600
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
IDLE DISPLAY Idle Display
If a real-time clock (RTC) is installed, this parameter selects the LCD options for the
RTC.
Default: FW Version
Selections: FW Version, MM/DD/YY 24HR, MM/DD/YY 12HR, DD/MM/YY 24HR,
DD/MM/YY 12HR
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
RTC DATE RTC Date
If the RTC is installed, this parameter allows changing of the date.
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value of the selected digit.
3. Press MINUS (–) to move to the next digit.
4. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters and Other LCD Displays (Sheet 14 of 15)
Parameter Action/Explanation